Page in Progress/building

VW- Caravelle -California Beach-VW rail system

Our units are designed to be a universal fit but this page is intended to be a fitting resource for VW t5 and t6 vans with the factory rail system.ie Volkswagen Caravelle-California Beach etc.
 All of our units have fitting/mounting slots in the floor of the unit. When combined with our anchor cleats either/and mounting plate, the idea is to make the fitting as easy as possible.

Anchor cleat

 The Vangear cleat is designed to slide into the Vw rail system and to be held in place with the two small set screws. Can be used on their own or with our mounting plate. 

Mounting slots
Mounting slots allowing for adjustment and with our new hole at the end of the slot to allow the allen key bolt to remain in place on fitting/removing of the unit.

Mounting plate
Can be used with our cleats or fixed directly to the floor (new holes can be drilled) 

Vangear Nano

The Nano (300mm x 600mm) mounted with cleats onto the rail system in a T6.

Vangear Mini

The Mini (475mm x 600mm) mounted with cleats and a mounting plate. The Mini should work with the 3 seat VW seat bench and many rock and roll beds but not the 2 seat (California bed)as it is longer folded down.Please check dimensions as models vary.

Modular system

LHD shown mounted with cleats for both the Maxi unit and wheel arch unit. In a VW Caravelle or VW Beach the units will have to go on the left hand side(as per the California Ocean) because of the side door and the rear fan pack  ( on the right hand side of the boot) 


The units are 420mm deep and can be used with the RIM 1120 rock and roll bed and many others. These units will not work with the VW California factory rock and roll bed as it is slightly wider.

More information and diagrams soon